Not all tile is created equal. This is not to infer that we are talking about the size, shape or thickness, but rather the durability of the tile in extreme environments.
Almost everyone who has installed or helped to install porcelain or glass mosaic tile has had to correct the age-old problem known as thin-set mortar squeeze-up between each tile.
Grout goes in the grout joints and sealant goes in the locations designated as movement accommodation joints by the design professional or engineer, but sometimes it doesn’t work out as planned.
Many times, when ceramic tile is installed, we, as installers, may not use all of the tile industry standards to our best advantage. These standards can be the installer’s best friend when assisting the consumer, whether residential or commercial, in deciding the grout joint size and pattern.
The standards found in the ANSI (American National Standards Institute) A108.02 document provide the installation method standards used to provide a good looking and long-lasting tile project. When they are followed, the job is headed for success, but when they are not followed, it may be doomed from the beginning.
The tile industry has established installation standards in the American National Standards Institute (ANSI) documents to guide all involved: the design professional, the general contractor and the tile installer.
When the time comes to physically look at a potential job, there are many aspects of the project that must be reviewed, including the condition of the walls.
Many times, a jobsite is not well maintained or kept clean which can be an image and possibly a safety issue, but more importantly, when tile is being installed, the substrate must be clean.
RSS
